Removing Engine Compartment Components

Fig 1: Engine Compartment Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

• the engine cover

Remove: 

• Upper engine stabilizer brace. Remove mounting screws for the torque rod
• the screw and nut for the engine mounting and torque rod
• the engine stabilizer brace.
• the air cleaner (ACL) housing assembly and the fresh air intake hose.

  Unhook the turbocharger (TC) control valve and the connector from the air cleaner (ACL) housing. Pull the air cleaner (ACL) housing out of its mountings.

  Fig 2: Torque Rod And Mounting Screws

  

Fig 3: Engine Hoses

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

• the charge air pipe for the turbocharger (TC). Leave the hose in place on the turbocharger (TC)
• the hose between the intake manifold and the charge air cooler (CAC) from the intake manifold. Fold the hose to one side
• the clamp for the cable harness on the engine
• the nut for the rear engine pad. Leave the nut in place on the engine pad by a few threads.

Disconnect the inner of the two hose couplings from the connecting sleeve for the passenger compartment heater in the firewall.