LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> Transmission >> Clutch >> Clutch - Removal, Replacement And Installation >> Throw Out Bearing (B5204T5, M56; 2004-2007) >> Clutch Slave Cylinder >> Removing The Clutch Cylinder

Removing The Clutch Cylinder

Fig 1: Identifying Clutch Cylinder
GLL109088Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the rubber seal from the clutch cover. Move it inwards on the pipe towards the clutch cylinder.

Pull out the locking bracket that locks the quick-release connector on the pipe to the junction. The locking bracket sits on the outside of the clutch cover.

Remove the junction: Install a protective plug in the end of the pipe.

Remove the two screws holding clutch cylinder. Remove the cylinder.

Clean the mating surfaces in the clutch cover. Check any leakage from the gearbox.

NOTE:

To replace the primary shaft seal, see Input Shaft Seal .

scientia non olet · About LEMON Manuals