Installing Clutch Disc's Centering Drift

Fig 1: Centering Tool Installed On Clutch Driven Plate

Courtesy of VOLVO CARS OF NORTH AMERICA.

Use centering drift 9995663 , alternatively together with 9995675 . The drift is modified with conversion kit 9989742 .

Remove the cone from the centering tool.

Install the centering tool in the flywheel center as far in as possible.

Use a wrench as a counterhold for the outer section of the centering tool. Tighten the nut so that the expander locks the centering tool in the crankshaft.

Feel that the drift is secured in the crankshaft.