Installing the tools on the clutch

Fig 1: Identifying Compression Tool & Counterhold

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install counterhold 9995677 , see Aligning The Counterhold For Automatic Clutch Adjustment .

Install the compression tool 9995662 , see Installing The Compression Tool .

First tighten the center screw on the compression tool to light contact. Then compress the clutch.

NOTE:

When the center screw comes into contact with the diaphragm spring, the screw should, for a loose clutch, be tightened a maximum of 4-4.5 turns .

Applies only to certain engine versions with self adjusting clutches:

NOTE:

When the center screw comes into contact with the diaphragm spring, the screw should, for a loose clutch, be tightened 4.5 - 5 turns or until a clear click is heard .