Pressure Sensor Tire

Operation Number(s): 38641-2

NOTE: Removal steps in this procedure may contain installation details.

Remove the wheel.

Fig 1: Identifying Marked Area

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION: Do not use tools within the marked area.

CAUTION: Always start outside the marked area and continue in the direction from the valve.

CAUTION: Release the tire bead from the wheel rim diagonally opposite to the valve.

Remove the tire from the rim.

Fig 2: Identifying Sensor & Valve

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Always use new valves when replacing tires.

Remove the following items:

sensor from valve.
valve.

Install the sensor on the valve. Tighten screw. See Tightening Torque .

Fig 3: Identifying Valve

Courtesy of VOLVO CARS OF NORTH AMERICA.

Brush the valve (1) with soapy water and install the valve on the rim.

Fig 4: Identifying Marked Area

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION: Do not use tools within the marked area.

CAUTION: Always start outside the marked area and continue in the direction from the valve.

Fit the tire and balance the wheel.

Install wheel. See Installing Wheels

After replacing sensors, the control module does not need programming. The control module contacts the sensor itself after a few minutes driving. LF initiator can be used.