Installing the Rear Wheel Hub

Fig 1: Installing Rear Wheel Hub And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

(The figure displays the rear wheel hub schematically)

Install 

• the rear wheel hub. Use new screws and torque wrench with ring wrench kit. Tighten crosswise. Tighten to 20 Nm  .

  Then tighten to 65 Nm  .

  Finally angle-tighten 60°  . Use bevel protractor 9512050 .

  In the event of difficulty using the bevel protractor, see Screwed Joint, Torque/Angle Tightening .

Fig 2: Brake Disc And Locating Pin

Courtesy of VOLVO CARS OF NORTH AMERICA.

• the brake disc
• the locating pin for the brake disc. Tighten the locating pin. Tighten to 10 Nm 
• the brake caliper. Use new screws. Tighten to 60 Nm 
• the ABS sensor.
  NOTE: Ensure that the sensor seat in the wheel spindle is completely  clean. Clean the ABS sensor with a soft brush. Tighten the sensor. Tighten to 10 Nm  .
• the ABS-cable holder
• the wheel. See Installing wheels .