Installing the spring

Fig 1: Removing/Installing Spring Use Hydraulic Piston, Claw And Extension Rod

Courtesy of VOLVO CARS OF NORTH AMERICA.

Use hydraulic piston: 9512911 using claw: 9512913 and extension rod: 9512937 .

Compress the new spring. Thread it into the control arm.

NOTE: Ensure that the spring is gripped in the same place as the old spring.

Install:

Remove the hydraulic piston: 9512911 using claw: 9512913 and extension rod: 9512937 .

NOTE: Lubricate the rubber ring using soap solution for easier installation.

Fig 2: Twisting Spring Until There Is A Clearance Of 15 mm Between End Of Spring

Courtesy of VOLVO CARS OF NORTH AMERICA.

Twist the spring until there is a clearance (A) of 15 mm between the end of the spring and the raised portion of the control arm.