Removing the Spring

Fig 1: Removing/Installing Fixing Nut On Shock Absorber Using Socket And A Torx-Wrench As A Counter Hold

Courtesy of VOLVO CARS OF NORTH AMERICA.

Relieve the load on the spring seat using hydraulic tool 9512911 together with plates 9512914 .

Remove: 

• the fixing nut on the shock absorber. Use socket 9995469 and a 3/8" Torx-wrench as a counterhold.
• the spring seat
• the spring
• the rubber bump stop and gaiter.

Fig 2: Shock Absorber Support Plate, Spring Seat And Rubber Bump Stop With Boot

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the shock absorber support plate (1), the spring seat (2) and the rubber bump stop with boot (3) are undamaged. Replace if necessary.