Installing the Spring Strut

Fig 1: Nuts Holding Spring Strut Mounting In Bodywork

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fit the spring strut in the body with new nuts, 3 pcs. M8.

Pull up the shock absorber's lead in the engine compartment and plug in the connector by the suspension turret.

Fit the lead in the clips.

Fig 2: Installing Spring Strut On Wheel Spindle

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the spring strut on the stub axle. Use new screws and new nuts.

Adjust the spring strut and stub axle to the measured value.

NOTE: Ensure that measurement is performed at same points as when removing.

Tighten the screws according to Tightening Torque .