Checking the component

Measure the resistance between pins terminals #8 and #6 on the chassis switch lock unit.

The ohmmeter should read approximately 5 ohm.

Other information 

• To remove the lock unit, see Replacing the switch for the lock unit / cargo compartment lighting
• For information about signals see Signal specification .

Fig 1: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the value correct? 

• YES 

  Refer to Function test 

• NO 

  Refer to Replacing lock unit 

Measure the resistance between pins terminals #7 and #6 on the chassis switch lock unit.

The ohmmeter should read approximately 5 ohm

Other information 

• To remove the lock unit, see Replacing the switch for the lock unit / cargo compartment lighting
• For information about signals see Signal specification .

Fig 1: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the value correct? 

• YES 

  Refer to Function test 

• NO 

  OKAY:  Troubleshooting has been completed.