Checking the wiring
- Ignition off
- Disconnect connector from the seat heater module.
Check the cable between fuse 11C/8 terminal #2 (25A) and seat heater (9/12) for left seat and (9/13) for right seat connector terminal #1. Check for a short-circuit to ground.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- For information about signals, see Signal specification
- See Checking wiring and terminals .
Is the cable OK?
- NO
Refer to Checking the cable
- YES
OKAY: Troubleshooting has been completed.
Check the cable between fuse 11C8 terminal #2 (25A) and seat heater (9/12) for left seat and (9/13) for right seat connector terminal #1. Check for contact resistance and oxidation. Check for an intermittent open-circuit.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- For information about signals, see Signal specification
- See Checking wiring and terminals .