Checking the wires

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Remove connector from central electronic module (CEM).

  Check the wire between fuse 11C/32 2 (10A) and central electronic module (CEM) connector 6E for a short circuit to ground as described in Short-circuit to ground, permanent faults .

  Do the necessary corrective action.

  Additional information: 

  • For information on the central electronic module (CEM) connector, see CENTRAL ELECTRONIC MODULE (CEM), REPLACING
  • To connect a test box, see Connecting the breakout box
  • For information on signals, see Signal specification .
  Fig 2: Identifying Breakout Box

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 3: Identifying Ohmmeter

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Are wires OK? 

• YES 

  Refer to Checking the wires 

• NO 

  OKAY:  Troubleshooting has been completed.

Check the wire between fuse 11C/32 2 (10A) and central electronic module (CEM) connector 6E for an intermittent short circuit to ground as described in Short-circuit to ground, intermittent faults .

Do the necessary corrective action.

Additional information: 

• For information on the central electronic module (CEM) connector, see CENTRAL ELECTRONIC MODULE (CEM), REPLACING
• To connect a test box, see Connecting the breakout box
• For information on signals, see Signal specification .

Fig 1: Identifying Breakout Box

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check the wire between fuse 11C32 2 (10A) and central electronic module (CEM) connector 6E for contact resistance and oxidation as described in Contact resistance and oxidation , and for an open circuit as described in Open-circuit, intermittent faults .

Do the necessary corrective action.

Additional information: 

• For information on the central electronic module (CEM) connector, see CENTRAL ELECTRONIC MODULE (CEM), REPLACING
• To connect a test box, see Connecting the breakout box
• For information on signals, see Signal specification .

Fig 1: Identifying Breakout Box

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.