Circuit test continued

Measure the resistance between terminal #2 and ground and between terminal #4 and ground on the cable connector.

1. The ohmmeter displays an incorrect value between terminal #4 and ground

   Refer to Checking ground lead 

2. The ohmmeter displays an incorrect value between terminal #2 and ground

   Refer to Checking the power supply 

3. The ohmmeter displays the correct value.

   FAULT NOT FOUND:  Troubleshooting has been completed.

Fig 1: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.