Checking the locking relay circuit
Remove the locking relay (2/58 (RMI 20)).
Check the cable between terminal #2 the cable and connector and terminal #3 on the relay base. Check for an open-circuit.
Remedy as necessary.
If no fault is detected, measure the resistance between terminal #4 in the relay base and ground.
The ohmmeter should read 0 ohm.
If the resistance is incorrect, replace the rear electronic module.
Other information
- To access and replace the rear electronic module, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing
- To access the lock unit, see Electric motor, fuel tank filler cover, replacing
- See Checking wiring and terminals .