Checking wiring and connectors
Check the wiring between:
connector terminal #5 for the fuel level sensors and rear electronic module terminal # A02 (#A2)
connector terminal #6 for the fuel level sensors and rear electronic module terminal #A10 (#A10)
connector terminal #7 for the fuel level sensors and rear electronic module terminal #A8 (#A8)
check for an open-circuit. Check for a short-circuit to supply voltage.
Check the relevant connectors. Check for contact resistance and oxidation.
Remedy as necessary.
Other information:
- For further information about signals and other values, see Signal specification
- To connect the breakout box, see Connecting the breakout box
- To access the integrated relay / fusebox in the cargo compartment, see Integrated relay/fuse box cargo compartment/rear electronic module, replacing
- To access the connector for the fuel level sensors, see Left fuel gauge sensor and Right side fuel pump with level sensor
- See Checking wiring and terminals .
Was a fault detected?
- YES
OKAY: Troubleshooting has been completed.
- NO