Verification, continued

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Reinstall the connectors, components etc.
• Ignition on.
  NOTE:

  It is important that only the ignition is on in order for the heater to start.

• Activate the heater.

  A buzzing sound should be heard from the heater.

  HINT: After repair, the voltage of the flame sensor can be checked. The voltage should be a maximum of 1.0 V. 

  Check the function of the heater. See Engine coolant heater, test running .

  Other information: 

  • For a description of parameters, see Description of parameters
  • For a description of activations, see Activating components/functions .
  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Does the heater operate? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to Information