Removing the WHIPS system
Remove:
- the seat from the car. See Lifting the front seats in and out
- the lumbar support knob. See Lumber support adjustment knob, replacing
- the backrest adjustment knob. See Backrest adjustment knob
Turn the adjuster or run the backrest adjustment to the maximum reclining position.
Release the adjustment mechanism (C). Fold the backrest forwards.
NOTE:
Be careful when the spring releases. There is considerable force in the spring.
Remove the spring (D).
Remove:
- the indicator pin or its remains.
This applies only to cars up to the following chassis number.
S60: -1499
- one nut (B) on each side
- one spindle (E) from each side.
Pull the end mounting apart.
Remove the deformation element (F), the plastic washers and the O-ring.
Replace the deformation element.
NOTE:
The O-ring (A) in the repair kit must be used for all models.