Installing the Inflatable Curtain
NOTE:
If the inflatable curtain module is dropped, it must not be installed.
Install:
- clip C
- screw 1 (screw in until the thread engages only).
Remove the packaging by pulling it straight downwards.
NOTE:
Ensure that no bits of paper remain.
Install:
- screws 2 and 8.
(4 and 5 are installed when installing the grab handles)
Hook on the IC (inflatable curtain). Install screw 3.
NOTE:
It is very important that the hook is correctly installed.
Install:
- clip G.
(6 and 7 are installed when installing the grab handles)
Tighten screws 1-7. Tighten to 10 Nm .
Install:
- The connector
- The headlining. See Headlining, Replacing
CAUTION:
When installing the IC (inflatable curtain), part of the decal on the curtain must be ripped off and stuck on the decal in the door opening.