Removing Seat Airbag Modules (SIPS)

Remove the seat from the vehicle. See Lifting the Front Seats In And Out .

Release the tension in the lumbar support.

Remove the lumbar support adjustment knob. First unscrew the knob counter-clockwise as far as it will go. Continue screwing counter-clockwise and pull out hard.

Remove:

the side piece by pulling it straight out
the backrest adjustment knob. Pull the knob straight out. This applies only to manual seats
the 5 half moon clips from the bottom of the backrest.

Remove the upholstery up to the first lateral channel. There are 2 half moon clips on each front-rear channel.

Remove 3 half moon clips from the first lateral channel.

Fig 1: Five Half Moon Clips At Bottom Edge Of Backrest

GLL110057

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove another half moon clip from each side of the front-rear channels up to the upper front-rear channel.

Fig 2: Identifying Spring

GLL110045

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the 2 elastic attachments on the inside/reverse of the backrest.

Pull up the backrest upholstery.

Bend out and expose the protective pad on the side where the airbag is located.

Fig 3: Removing 2 Screws Holding Airbag To Inside Of Backrest Frame

GLL110044

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the 2 screws holding the airbag to the inside of the backrest frame.

Pull the airbag downwards. Fold the airbag slightly forward.

Remove the airbag.

Fig 4: Cable Tie

GLL110047

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cut the tie strap.

Fig 5: 3 Half Moon Clips From Rear Edge Of Underside

GLL110048

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cut off the 2 tie straps.

Release the cable harness.

Replace the airbag.