LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Interior Equipment - General Safety Information) >> Seat Belts And Other Retention Systems (1999-2006) >> Handling Non-Deployed SRS-Components >> IC (inflatable Curtain) Module, Replacing >> Removing Inflatable Curtains

Removing Inflatable Curtains

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Inflatable Curtain
GLL107609Courtesy of VOLVO CARS OF NORTH AMERICA.

First read Preparation .

NOTE:

The hose clamp must not be opened under any circumstances. If the clamp is opened, it will not be possible to guarantee the safety of the joint. Leakage may result which would compromise the function.

Remove: 

Fig 2: Identifying Igniter Wire Connector
GLL107610Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

Fig 3: Clips G & D
GLL105323Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

(6 and 7 are removed when removing the grab handle)

Fig 4: Identifying Bolts And Inflatable Curtain
GLL107611Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

(4 and 5 are removed when removing the grab handle)

Installing the inflatable curtain 

NOTE:

If the inflatable curtain module is dropped, it must not be installed.

Fig 5: Identifying Bolts And Inflatable Curtain
GLL107611Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

Remove the packaging by pulling it straight downwards.

NOTE:

Ensure that no bits of paper remain.

Install: 

(4 and 5 are installed when installing the grab handles)

Fig 6: Clips G & D
GLL105323Courtesy of VOLVO CARS OF NORTH AMERICA.

Hook on the IC (inflatable curtain). Install screw 3.

NOTE:

It is very important that the hook is correctly installed.

Install: 

(6 and 7 are installed when installing the grab handles)

Tighten screws 1-7. Tighten to 10 Nm  .

Install: 

CAUTION:

When installing the IC (inflatable curtain), part of the decal on the curtain must be ripped off and stuck on the decal in the door opening.