Readiness Monitor (certain markets only)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

This is a function in Engine control module (ECM) that controls the control module's emission-related sub-system. With the function you can read out if the control module has run all diagnostics for the following sub-systems:

Misfiring
Fuel system
Catalytic converter
Evaporative emission (EVAP) system
Heated oxygen sensors (HO2S)
Other related components

Thus, Readiness refers only to if the diagnostics (tests) have been run or not, not if a malfunction was found or not. If a malfunction is found during the test, a diagnostic trouble code is stored and the malfunction light (MIL-light) is lit.

If the tests are run in the driving cycle without detecting a malfunction, then "Readiness" is immediately generated to OK.

However, if a malfunction is found in the driving cycle, then Readiness is generated to Not Ok, and another driving cycle is required where the test is run to generate Readiness to Ok.

The following alternatives are possible:

Readiness is run (Ok), no malfunction detected, which means that the vehicle can be approved in a check.
Readiness is run (Ok), with malfunction detected, which means that the vehicle cannot be approved in a check.
Readiness is not run (Not ok), which means that the vehicle cannot be approved in a check.

Readiness was originally a requirement from the American authority, United States Environmental Protection Agency (EPA), and is used there for Inspection and maintenance test (IM-test) (corresponds to annual inspection). Depending on legal requirements, the function may also be found on other markets.