Checking components and wiring

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

If the car is equipped with a 10-pin connector

Check the cable between door control module terminal #10B and power door mirror terminal #4 for an open-circuit according to Open-circuit, permanent faults , check for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults .

Check the cable between door control module terminal #8B and power door mirror terminal #6 for an open-circuit according to Open-circuit, permanent faults .

If the car is equipped with a 16-pin connector

Check the cable between door control module terminal #10B and power door mirror terminal #6 for an open-circuit according to Open-circuit, permanent faults , check for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults .

Check the cable between door control module terminal #8B and power door mirror terminal #13 for an open-circuit according to Open-circuit, permanent faults .

Remedy as necessary.

Other information:

For further information about signals and other values, see Signal specification .
To connect the breakout box, see Connecting the breakout box .
To access the connector for the power door mirror, see Outside temperature sensor door mirror, replacing .
To replace the bulb in the power door mirror, see Bulb, ground lighting, door mirror, replacing .

Fig 1: Identifying 10--Pin Power Door Mirror Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohms Display

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying 16-Pin Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.