Checking components and wiring
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
If the car is equipped with a 10-pin connector
Check the cable between door control module terminal #10B and power door mirror terminal #4. Check for an open-circuit. Check for a short-circuit to supply voltage.
If the car is equipped with a 16-pin connector
Check the cable between door control module terminal #10B and power door mirror terminal #6. Check for an open-circuit. Check for a short-circuit to supply voltage.
Remedy as necessary.
Try replacing the power door mirror if no fault was found.
Other information:
- When the button is not depressed, the voltage between terminal #10B on the control module connector and ground must be 0 V
- For further information about signals and other values, see Signal specification
- To connect the breakout box, see Connecting the breakout box
- To access and replace the power door mirror, Model years -2003, see Door mirror, replacing . Model years 2004-, see Door mirror, replacing .
- See Checking wiring and terminals .