Replacing the driver/passenger door module (DDM/PDM)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
The driver/passenger door module (DDM/PDM) has registered an internal fault.
CAUTION:
A new control module is delivered without software. The control module must be programmed when it has been replaced.
After replacing the control module the window position must be initialized.
Move the window to its upper limit position using manual control.
Initialize the window.
From model year 2003 inclusive, the window will lower approximately 10 centimeters and then close again during initialization.
Other information:
- For information about programming and replacing the driver/passenger door module (DDM/PDM), see Driver's door module / passenger door module (DDM/PDM), replacing .