Installing the outer module
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Clean the glass using a razor blade or similar.
Clean the glass using the cleaning cloth supplied with the outer module.
Cut out a template corner to corner with the inner module.
Position the template edge to edge with the inner module. Tape the template into place.
NOTE:
The outer and inner modules must be positioned opposite each other.
To ensure optimal adhesion, carefully heat the glass. Use a hot-air gun or similar.
Remove the backing from the outer module.
Position the module in the correct place on the glass. Press the module into place. Press the module against the glass for 3-4 seconds.
NOTE:
Ensure that the tape adheres correctly all the way around the mounting for the outer module.
Remove the template.
Reinstall other components in reverse order.