Installing the water pump for the engine coolant heater
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Position the water pump (according to the noted position) in the shutter using the shaped hoses.
Install:
- the water pump mounting using a nut (1xM6). Tighten to 3 Nm
- the connector
- the protective cap
- a new tie strap.
Tighten the hose clamps for both the engine coolant hoses.
Install the control module. See Control module engine coolant heater, replacing .