Fuel injection nozzle/fan motor/pressure equalizer, replacing: Installation: Wires

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Flame Sensor & Rubber Bushing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the tie strap.

Connect the wiring to the blower fan motor.

The cables must be routed under the nozzle pipe.

Install the flame sensor.

NOTE: Ensure that no cables are routed under the flame sensor.

Install the fan shroud (3 screws).