Climate control unit, replacing: Installation: Finishing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

After replacing the control module, the following must be carried out.

Reprogram the customer programmed data.
Carry out self-adjustment of the damper motor end positions.
Test drive the car. Check that the function of the engine is OK.
Then check that no diagnostic trouble codes have been stored during the replacement.

Information about programming the control module, damper motor self-adjustment and reading off diagnostic trouble codes can be found under VIDA vehicle communication.