Installing hoses

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Position the refrigerant pipe against the firewall
Position the front section.

NOTE: Use new O-rings lubricated with compressor oil.

Carry out other work in reverse order.

Vacuum pump the system and leak test. See Refrigerant, draining
Fill the system with refrigerant and check for leaks. See Refrigerant, draining
Connect the battery negative lead. See Battery, replacing

Tighten to:

Tighten the hose/pipe coupling to the junction point on the side member. Tighten to 25 Nm .

Tighten the pipe coupling to the receiver. Tighten to 10 Nm .

Tighten the pipe coupling to the expansion valve. Tighten to 10 Nm .

Tighten the mounting for the pipe between the expansion valve and the side member. Tighten to 25 Nm .

Tighten the protective cap for the filling valve. Tighten to 6 Nm .