Pipe/hose, compressor, replacing: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Always use new O-rings lubricated with compressor oil

Fig 1: Lowering Air Conditioning Aggregate On Left-Hand Side

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position the pipe/hose in the mounting on the condenser. Position the pipe coupling.
Thread and tighten the screw by hand as much as possible
Tighten the screw for the pipe coupling from the compressor. Tighten to 25 Nm .

Fig 2: Identifying Lower Mounting For Air Conditioning Aggregate

Courtesy of VOLVO CARS OF NORTH AMERICA.

Locate the air conditioning aggregate against the rubber seals. Tighten the lower screws for the air conditioning aggregate. Tighten to 25 Nm
Check that the seals are correctly positioned.

Fig 3: Air Baffle

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the air baffle.