Expansion valve, replacing: Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Always use new O-rings lubricated with compressor oil.
- Install the O-rings on the pipe from the evaporator
- Install the expansion valve. Thread on the screws. Tighten the screws. Tighten to: 10 Nm
- Install the O-rings on the pipes
- Position the pipes and the holders towards the expansion valve. At the same time check that the pipes are on the correct holder at the member
- Thread in the screw. Tighten the holder with the pipes on the expansion valve. Tighten to: 10 Nm
- Install the heat shield. Secure the heat shield using the plastic nuts
- Press the clamp together on the member
- Install the engine stabilizer brace in the engine compartment. 5 cylinder engine . See Replacing cross stay/upper torque rod
- Install the engine stabilizer brace in the engine compartment. 6 cylinder engine . See Replacing cross stay/upper torque rod
- Vacuum pump and test the system. See Refrigerant, draining
- Fill the system with refrigerant. Check for leaks according to Refrigerant, draining
- Connect the battery negative lead. See Battery, replacing