Installing the receiver drier
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Always use new O-rings lubricated with compressor oil.
Position the receiver/dryer on the bracket and mount the pipe from the condenser.
Thread in the screw for the bracket.
Tighten the screw for the condenser-receiver/dryer's pipe coupling.
Tighten to 10 Nm
Tighten the screw for the bracket.
Tightening torque 25 Nm
Install the condenser acc. to Condenser, replacing .