Receiver drier, replacing: Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For tightening torques, see: Tightening torque
.
Installing the drier filter
NOTE:
Always plug the pipes and connections when working on the climate control system.
NOTE:
Use new O-rings lubricated with compressor oil.
Install:
- the dryer filter with the screw, 1 pc., from underneath acc. to Summary of tightening torques for specific components
- screw by the service valve, 1 pc. and tighten acc. to Summary of tightening torques for specific components
- the condenser, see Condenser, replacing .
NOTE:
For tightening torques, see Tightening torque
.
Installing the drier filter
NOTE:
Always plug the pipes and connections when working on the climate control system.
NOTE:
Use new O-rings lubricated with compressor oil.
Install:
- the dryer filter with the screw, 1 pc., from underneath acc. to Summary of tightening torques for specific components
- screw by the service valve, 1 pc. and tighten acc. to Summary of tightening torques for specific components
- the condenser, see Condenser, replacing .
NOTE:
For tightening torques, see Tightening torque
.
Installing the dryer filter
NOTE:
Always plug the pipes and connections when working on the climate control system.
NOTE:
Use new O-rings lubricated with compressor oil.
Install:
- the dryer filter with the 1 M8 screw (underneath) and tighten
- screw by the service valve, 1 pc. and tighten.
- the condenser. See Condenser, replacing .