LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Rear Axle, Drive Shafts - Removal, Replacement And Installation) >> Drive Shaft, CV Joint (B6284T, 4T65EV-Gt; 1999-2001) >> Half shaft, left, replacing >> Removal >> Remove the drive shaft from the transmission

Remove the drive shaft from the transmission

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Drive Shaft Removal From Transmission Using Jimmy Tool 999 5736
GLL109282Courtesy of VOLVO CARS OF NORTH AMERICA.

Use jimmy tool 9995736 .

Position the two jimmy tools opposite each other.

Detach the drive shaft.

NOTE: Pull the constant velocity joint  , not the drive shaft joints, when removing the drive shaft. There is no axial pinion.
NOTE: Take care not to damage the drive shaft when removing it from the transmission.

Install plug 9995730 on the transmission.

Fig 2: Identifying Rubber Seal & Constant Velocity Joint
GLL106610Courtesy of VOLVO CARS OF NORTH AMERICA.
CAUTION: Later models have a rubber seal on the constant velocity joint. Do not damage the seal. It will be needed for installation.
scientia non olet · About LEMON Manuals