Replacing the pilot bearing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Press out the pilot bearing from the drive shaft

Fig 1: Supporting Socket And Shaft Using Jointed Ring 999 2853

Courtesy of VOLVO CARS OF NORTH AMERICA.

Use jointed ring 9992853 . Support the socket and shaft as shown.

Install the new bearing on the shaft

Fig 2: Using Press Ring 999 5491 As Support Against Bearing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Use press ring 9995491 as support against the bearing. Turn it as shown.

Position socket 9992842 at the base of the universal joint.

Press the bearing against its seating on the shaft.