LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Rear Axle, Drive Shafts - Removal, Replacement And Installation) >> Drive Shaft, CV Joint (B6284T, 4T65EV-Gt; 1999-2001) >> Boot CV joint housing, replacing >> Cleaning/checking the outer constant velocity joint >> Install the inner ring in the bearing race

Install the inner ring in the bearing race

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Inner Ring & Ball Holder
GLL109789Courtesy of VOLVO CARS OF NORTH AMERICA.

Line up the markings with each other. Install a ball bearing.

NOTE: Ball location.

Turn the inner ring and the bearing race.

Install the balls one by one in the same positions as before. See Remove the ball bearings .

scientia non olet · About LEMON Manuals