Removing the connecting socket
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Place a container underneath the gearbox. Ensure that the piston rod in the puller cylinder is in the outer position.
Position sleeve 9995777 between the puller cylinder and the transmission. Press in the expander so that it enters the groove on the connecting sleeve.
Apply the puller cylinder. Check that the socket between the gearbox and the puller cylinder is in contact with its support surfaces.
Remove the socket.