Installing the sealing ring for the CV joint housing on the wheel spindle

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rubber Seal & Constant Velocity Joint

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Replace the sealing ring if it is damaged or worn.

Clean around the constant velocity joint before installing the sealing ring.

Carefully install the sealing ring. Ensure that the sealing ring is correctly positioned on the drive shaft.