Removing components from the Active on Demand coupling
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Remove the throttle valve and the temperature/pressure sensor from the coupling.
A = Throttle valve.
B = Temperature/pressure sensor.
Use a large pair of pliers for removal. Grip the end of the throttle valve. Hold the pliers stable and pull the valve straight out.
NOTE:
Make sure that no damage is caused when removing the throttle valve. The valve cannot be replaced separately. The throttle valve is removed in order to be installed in the control module. This is done to minimize the risk of damage occurring to the contacts when installing.
Remove:
- the temperature/pressure sensor as above
- the O-ring from the throttle valve seat in the coupling housing.