Removing the oil pump

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Thoroughly clean around the oil pump before beginning removal.

Fig 1: Locating Oil Pump Connector And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position a container underneath the Active on Demand Coupling.

Disconnect the connector for the oil pump. Remove the tie strap.

Remove the bracket and the connector for the control module.

Remove the 2 screws for the oil pump. Pull the pump straight out of the coupling.

NOTE: Later versions of the oil pump have the socket for the cable harness on the side of the oil pump housing. The cable harness is shorter. This version supersedes all previous versions, including as a replacement part.