Removing the final drive from the rear axle member

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Positioning Mobile Jack 998 5972 Together With Fixture 999 5972

Courtesy of VOLVO CARS OF NORTH AMERICA.

Position mobile jack 9985972 together with fixture 9995972 .

Adjust the plate against the lower cover and final drive.

Install a large hose clamp or several clamps put together over the coupling (AOC (Active on Demand Coupling)/final drive and the plate.

Remove:

the front screw for the final drive
the 8 screws for the cover/rear axle member.