Preparations for the installation of the final drive
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Lift the final drive together with the drive shafts so that the center of the drive shaft is slightly below the center of the wheel bearing housings.
Apply rust-proofing agent to the ends of the drive shafts.
Press out one of the wheel bearing housings. Align the drive shaft in the hub.
Then align the other side.
Lift a little more and connect the bleed hose to the nipple on the final drive housing. Check that the hose is secured to the rear axle member by the tie strap and that it is not kinked.