Removing the front bushing from the final drive housing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Use puller cylinder 9512564 or 9995575 and associated pump 9995576 . Place connecting rod 9995588 in the puller cylinder and sleeve 7078-2 against the puller cylinder and the bushing.
Position counterhold 9997078 and washer 7078-1, turn the counterhold so that the cut-out is facing the radius of the final drive housing and so that it is supported on the surrounding cast surface.
Press out the bushing.