Marking the bushing and final drive housing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
To achieve the correct position of the bushing when installing. Make a mark directly opposite the cut-out in the edge of the bushing and straight down the side.
Make a mark directly opposite the edge that is formed between the cast surface and the machined surface on the final drive housing, as shown.
Position the mark on the bushing directly opposite the mark on the final drive housing.