Removing the front bushing from the final drive housing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of VOLVO CARS OF NORTH AMERICA.
Remove the washer that is pressed onto the top of the bushing. Use a screwdriver.
Use hydraulic tool
9995576
with puller cylinder
9995575
or
9512564
.
Install:
- threaded rod
9995588
for the puller cylinder
- drift 5767-1 for the puller cylinder (turned with the cut-outs towards the support lugs in the final drive housing)
- counterhold
9995767
on top. Press out the bushing.