Installing the front bushing in the final drive housing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Final Drive Housing Front Bushing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Lubricate the outer sleeve of the new bushing with petroleum jelly.

Position the new bushing with the beveled edge towards the final drive housing.

Install:

drift 5767-1 with counterhold 5767-2
drift 5767-3 against the bushing.

Push in the bushing until it reaches the support lugs in the final drive housing.

Install the washer on top of the bushing. Press the washer into place using the screw for the bushing and a nut.