LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2002 >> S60 Base, 2.4 61, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Suspension Module (Sum) - Specifications, Electrical/Electronic) >> Specifications For The Suspension Module (Sum) (2005-2009) >> Component Specifications

Component Specifications

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

The component specification gives the value of the component when the connector is disconnected. Where no value is given, it is not possible to measure a relevant value at the component.

The figure within the brackets indicates the terminal pin on the component to which the value refers.

Designation  Type  Supply voltage  Value  Other 
Acceleration sensor suspension, left and right-side front - 5 V
(#5)
Output signal (terminal #1) 0.5 V - 4.5 V Resistance readings cannot be taken
Position sensor suspension, left and right sides rear - 5 V
(#5)
Output signal (terminal #1) 0.5 V - 4.5 V Resistance readings cannot be taken
Acceleration sensor body - 5 V
(#5)
Output signal (terminal #1) 0.5 V - 4.5 V Resistance readings cannot be taken
Keypad - 5 V - -
Shock absorber solenoids - Ubat
(#1)
Pulse width modulated (PWM) signal Approximately 5 Ω(terminals #1-#2)