Checking the setting
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When adjusting the gear-shift position sensor, press the tool down to the flat surfaces below the thread on the shaft.
Remove the lever. Install adjustment tool 9995475 on the gear shift linkage rod. Check that the shaft is in the N position. The groove on the tool must align with the marking on the gear position sensor.
If adjustment is required, see the following procedure in this section.