Removing the lock-up solenoid

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Removing/Installing Lock-Up Solenoid

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove:

the connector from the solenoid and the cable harness from the holder
the spring clamp. Pull it straight out. Use a small screwdriver
the solenoid. Use a screwdriver between the solenoid and the housing. Check that the O-rings remain on the solenoid.