Installing the lock-up solenoid

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Removing/Installing Lock-Up Solenoid

Courtesy of VOLVO CARS OF NORTH AMERICA.

Apply a little petroleum jelly to the O-rings.

Install:

the solenoid. Turn and press in the solenoid a little so that it bottoms against the control system
the spring clamp. Check that the spring clamp is locked
the cable harness to the holder and the connector to the solenoid.